Foam Hand Sanitizer is characterized by foaming when they are extruded. In addition, there is no significant difference in composition from ordinary hand sanitizers.

Attentive people will find that ordinary hand sanitizers are particularly prone to solidification when the weather is cold. Under normal weather, it is squeezed out and needs to be rinsed with plenty of water. It is only relative to soap, there is no cross infection. But the foam hand sanitizer, through the magic pump head, presses out the rich foam directly, it is more convenient to wash the hands, the flushing is also very fast, and the water consumption is half of the ordinary hand sanitizer.

As a Hand Sanitizer Gel Supplier, we know that it is very convenient to use foam hand sanitizer because its special pump head is extruded into foam, which saves the process of washing water and foaming. It is also cheaper than ordinary hand sanitizer, which not only saves hand sanitizer, but also saves Water, ordinary hand sanitizer is generally squeezed out a lot, and then rinsed with water for half a day to clean, and the foam hand sanitizer is foam, it is easy to rinse; and the foam hand wash is cleaner, still Do not hurt your hand.

What is the use of lotion?

The foaming hand sanitizer acts like a normal hand sanitizer to cleanse the skin of the hands.

Foam hand sanitizer has the following advantages over ordinary hand sanitizer:

1, foam hand soap is easy to use: the pump head is extruded into a foam, eliminating the need for water to wash and foam.

2, the amount of savings: each use is 1/2 of the amount of ordinary hand sanitizer.

3, the effect is doubled: direct foaming, not easy to fall, so that the effective ingredients in the foam are fully utilized, greatly improving the effect of cleaning, sterilization and moisturizing.

The principle of the foam hand soap is that the bottle mouth has a special device to thoroughly mix the air with the foaming agent. I have never seen a fire-fighting foam gun. The middle school must have done such an experiment. The drooping paper strip floats to the place where the gas flows. Because the fluid has a decompression effect, the middle of the foam gun is a common gun head with a hole on the outside. When the foaming agent is sprayed from the middle of the sleeve, a large amount of air is sucked in from the side and mixed with it to generate foam because the air pressure is lowered.

Precautions when using foam hand sanitizer

When using hand sanitizer, do not press too much at a time, pay attention to the fingertips, finger joints, and let the foam cover all parts of the hand, hands rub each other for more than 30 seconds, then rinse with water no less than 15 second. Until the hands do not have the slippery feel of the hand sanitizer. To dry with a clean dry towel or paper towel, it is best not to dry, so as to avoid partial loss of water and dry skin.

When you wash your hands, don't just wash it off with water. It takes 30 seconds to wash your hands with hand sanitizer to ensure that the hand sanitizer penetrates into the surface of the skin. Dry naturally after washing and do not touch anything. In addition, if the hand is dried within 10-15 seconds, it means that the penetration of water and hand sanitizer is not deep enough, and the dosage needs to be deepened.

After using the hand sanitizer, the hands will feel dry. People who use hand sanitizer often can use some moisturizing hand cream after use. In addition, sometimes the hand soap is not as effective as soap. For example, when the hands are obviously dirty or the wounds are bleeding on the hands, the effect of the soap is far more than the hand sanitizer.